Clay-paky ALPHA SPOT HPE 700 Manuel d'utilisateur télécharger pdf (Page 21)

ALPHA SPOT HPE 700

LAMP HOURS

Used for displaying the lamp working hours (total and partial).

1) Press

- Hours total and partial appears on the display.

Total counter

Counts the number of projector working hours with the lamp on (from

manufacture to date).

Partial counter

Counts the number of lamp working hours since the last reset to date.

2) Press

to reset partial lamp working hours, a confirmation message

(

Are you sure ?) appears on the display.

3) Select YES to reset partial counter or NO to keep the current setting

and return to the top menu level

LAMP STRIKES

sed for displaying the number of times the lamp was turned on (total and

partial).

1) Press

- the number of times the lamp was turned on (total and

partial) appears on the display.

Total counter

ounts the number of times the lamp was turned on (from manufacture

to date).

Partial counter

Counts the number of times the lamp was turned on since the last reset

to date.

2) Press

to reset partial lamp strikes hours, a confirmation message

(Are you sure ?) appears on the display.

3) Select YES to reset partial counter or NO to keep the current setting

and return to the top menu level

SYSTEM VERSION

Used for displaying the software and hardware version of each board

installed in the projector.

CPU brd (CPU board)

0: PT-3f (Pan / Tilt board)

1: 8-Ch (8 channel board)

2: 8-Ch (8 channel board)

BOARD DIAGNOSTIC

Used for displaying the status error of each board installed in the projector:

0: PT-3f (Pan / Tilt board)

1: 8-Ch (8 channel board)

2: 8-Ch (8 channel board)

DMX MONITOR

Used for displaying the projector DMX channel level in bit (Val) and in

percentage (Perc).

FANS MONITOR

Used for displaying the speed of each fan installed in the projector:

Ball. IN (Ballast IN Fan)

Eff.IN (Effects IN Fan)

Lamp (Lamp Fan)

SENSOR STATUS

It lets you check the correct operations of each "sensor” installed in the

projector, each channel is associated with one of the following three

parameters:

• n.a.= sensor not available

• ON= sensor working

• OFF= sensor defective

NETWORK PARAMS

Allows the "Network" parameters of the projector to be displayed or:

IP address: Internet Protocol address (two projectors must not have the

same IP address)

IP mask: 255.0.0.0

Mac address: Media Access Control: the projector’s Ethernet Address

Lamp

Strikes

Total XXX

Partial XXX

Reset...

Lamp

Hours

Total XXX

Partial XXX

Reset...

Continue

➔

Network

params

System

Version

Board Revis. Hw.rv.

CPU brd x.x.x x.x

com.dev x.x

0: PT-3f x.x x.x

1: 8-Ch x.x x.x

2: 8-Ch x.x x.x

Board

Diagnost.

Dmx

Monitor

Board Status Err%

0:PT-3f Good 0.00

1:8-Ch Good 0.00

2:8-Ch Good 0.00

Fans

Monitor

Fan Speed (RPM)

Ball.In. XXXX

Eff.In XXXX

Lamp XXXX

Sensor

Status

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Clay-paky ALPHA SPOT HPE 700 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Clay-paky ALPHA SPOT HPE 700