• Fitting the accessory holder guides
Screw the two accesssory holder guides (5) into the threaded hole of the inserts
(17), and tighten them appropriately with the 8 mm double ended wrench (6)
supplied.
IMPORTANT: during this
operation, take care not to
turn the inserts (17) by
blocking them in their
position with the 16 mm
special wrench (7) also
supplied.
The accessory holder
guides (5) are electrified at
an extra-low safety voltage
(24V ac) and protected
against short-circuiting.
This permits installing the
entire range of motor driven
and timed accessories
available.
6
• Fitting projector mounting
Position the bracket (1) on the plates
(13) according to the desired height.
In correspondence with the chosen
hole, place the countersunk washers
(3) and the screws (2), then lock it all
with the aid of the Allen wrench
supplied (4).
Adjust the projector mounting in the
desired position and lock it with the
knobs (14).
The bracket (1) can also be fitted towards the bottom of the projector. To do this, it is
necessary to extract the knobs (14) from the rear hole and turn through 180° both
the plates (13) and the spacers (15), then re-insert the knobs (14) into the front hole.
IMPORTANT: The central screw (16) must never be removed so as not to jeopardize
the balance of the projector on the mounting.
•
Fitting the lens hood on the lens holder
If you wish to fit the lens hood
plate (10) on the lens mounting
(9), take out the 3 screws (19)
with the aid of a Phillips
screwdriver. Position the lens
hood plate (10) on the cover ring
(20) of the lens mounting (9)
and put back in the 3
screws (19) tightening
them appropriately.
• Fitting the lens
Insert the lens (8) into the mounting
(9) and tighten the handwheel (21).
Rest the lens mounting on the
guides (5) and lock it by turning the
fixing clips (22) inwards until they clip
on.
In addition to the lens supplied as
standard there is a vast range of
optional lenses.
• Fitting accessories for special
effects
Fit the desired accessories on the
guides, referring to the assembly
instructions provided with the
accessories.
• Inserting the lamp
Refer to the instructions for opening the projector and changing the lamp in paragraph
4 MAINTENANCE.
INSTALLATION
3
• Installing the projector
The fitting must only be secured with
the specific mounting, through the
hole in the bracket (1).
It is recommended to use a screw
ø10mm with nut and spring washer.
• Mains power connection
The projector has to be hooked up to the electricity mains via the specific socket (11)
supplied.
(4 pages)
(4 pages)
(4 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels